[Akiyuki] Zig Zag Lift

HOME Forums All GBC Modules – Tous les modules GBC [Akiyuki] Zig Zag Lift

Tagged: 

This topic contains 3 replies, has 2 voices, and was last updated by  turbopolofr 3 months, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #975

    turbopolofr
    Keymaster

    Exchange tips, advices and ideas about Zig Zag Lift in this topic
    ———
    Echangez des astuces, conseils et idées concernant Zig Zag Lift dans ce sujet

    #2364

    jimgag2395
    Participant

    The first ball to enter the lift only goes half way up the first ramp (DBG 1×7). The rest of the balls then clog up behind it. Any advice would be greatly appreciated!! Thanks

    #2401

    jimgag2395
    Participant

    The gear can not do a full turn. The blk 1×5 thin beam ( attaching the axles that are shorter) is coming up and hitting the bottom of the lbg bush. I’ve looked at it over and over. I can’t determine what I’ve done wrong. Any help would be greatly appreciated. I’ve included a link to a photo showing the problem circled in red. Thanks

    Zigzag stairs problem

    #2436

    turbopolofr
    Keymaster

    hello jimgag2395,

    DutchtreatNL informed me about roughly the same issue. He published a new version of the LXF file that I’ve just uploaded.
    Please check it to see if it supports you towards a working version of the module

    note: I do not have (yet) reproduced this one

    Turbopolor

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.