[Hugolinvh] Bidule à Balles

HOME Forums All GBC Modules – Tous les modules GBC [Hugolinvh] Bidule à Balles

This topic contains 2 replies, has 3 voices, and was last updated by  Snapshot 9 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #2788


    Exchange tips, advices and ideas about Bidule à Balles in this topic
    Echangez des astuces, conseils et idées concernant Bidule à Balles dans ce sujet



    Very clever design!

    We hade two of these in a 4-day event last weekend and we encountered the same issue with both.

    When running a GBC-circuit for a while the balls tend to get dirty.
    They get almost like wax-like dark stains in them.
    The dirty balls gets stuck in the Bionicle teeth and oncoming balls fall out.

    Needs clean balls to run properly.



    I had a problem during a two-day show: the three 54200 ‘cheese’ slopes in the initial three-legged ball collector kept either falling off or twisting, causing balls to jam. A permanent fix was required…..

    Also, it will not work with PV-Production balls as they’re slightly too small and don’t pass along the chain of teeth reliably. Obviously, not the fault of the module but I thought something had gone wrong when I tried them.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.